In some of the vehicles, a short circuit could allow continuous current flow through the switch, producing enough heat to possibly start an electrical fire in the door.
12.
The star-wound alternator produced a excitation current was supplied by the exciter, a continuous current generator joined directly to the general base that, at full charge, had 170 Volts CC with a 340 Amp intensity.
13.
Another way to mitigate arc flash is to use a triggered current limiter or commutating current limiter which inserts a low rated continuous current current limiting fuse that melts and interrupts the arc flash within 4 ms.
14.
This mode of operation is referred to as " current " mode, meaning that the output signal is a continuous current, and not a pulse output as in the cases of the Geiger-M�ller tube or the proportional counter.
15.
Volta made numerous experiments in support of his theory and ultimately developed the pile or battery, which was the precursor of all subsequent chemical batteries, and possessed the distinguishing merit of being the first means by which a prolonged continuous current of electricity was obtainable.
16.
In the 1970s, Hewlett-Packard reported ( in an article in " HP Journal " about the design of the HP-35 calculator ) that an LED repeatedly pulsed "'very "'briefly appeared brighter to the human eye than an LED carrying a continuous current with the same average value.
17.
During a test run to Volksrust, various adjustments were made to the water circulating arrangements, which improved the power output to the extent that the tram traction motors were unable to stand the continuous current which was generated, and they were replaced by two Siemens traction motors, supplied by General Electric.
18.
Although the basic technology for analog computers is usually operational amplifiers ( also called " continuous current amplifiers " because they have no low frequency limitation ), in the 1960s an attempt was made in the French ANALAC computer to use an alternative technology : medium frequency carrier and non dissipative reversible circuits.
19.
:: : : It would work ok as a sounder, but if the coil received " .-. . " the electrical output ( assuming the U shaped piece and the movable armature were connected in series with a local circuit ) would be a continuous current with very brief interruptions between each dot and dash.
20.
Typically, this continuous current flow is controlled by at least two TFTs at each pixel ( to trigger the luminescence ), with one TFT to start and stop the charging of a storage capacitor and the second to provide a voltage source at the level needed to create a constant current to the pixel, thereby eliminating the need for the very high currents required for passive-matrix OLED operation.
