In their experiments, it remained liquid for twelve hours as it gradually cooled below the eutectic temperature before eventually it froze at 15.5 degrees below the eutectic temperature.
12.
"Semi-solid die casting " uses metal that is heated between its liquidus and either solidus or eutectic temperature, so that it is in its " mushy region ".
13.
The chosen bonding temperature usually is some degrees higher than the eutectic temperature so the melt becomes less viscous and readily flows due to higher roughness to surface areas that are not in atomic contact.
14.
The density of this alloy is 8.86g / cm 3, tensile strength of 37 MPa, toughness of 12HB, eutectic temperature of 320K ( 47 �C; 116.6 �F ).
15.
Upon heating any other mixture ratio, and reaching the eutectic temperature see the phase diagram to the right one component's lattice will melt first, while the temperature of the mixture has to further increase for ( all ) the other component lattice ( s ) to melt.
16.
Here is a table of some salts likely to be found on Mars, showing the eutectic temperature for each one ( with the molar concentration for the optimal eutectic concentration in brackets ) and the amount of supercooling below that temperature that they found with experiments ( adapted from table 2 of-omitted some of the columns ).
17.
The way it's usually explained, as in here, is that as we cool down the melt, compound A solidifies, then at the eutectic temperature, B starts to solidify at constant temperature, and after that all we have in the system is solids A and B and the systems can only cool down after that.
18.
A "'eutectic system "'( ) from the Greek " ?? " ( eu = easy ) and " ????? " ( teksis = melting ) describes a homogeneous melts as a whole ", at a specific temperature ( the eutectic temperature ) " the super-lattice releasing at once all its components " into a liquid mixture.
19.
This alloy presents a density of 8.58g / cm 3, tensile strength of 43 MPa, toughness of 14HB, eutectic temperature of 331k ( 58 �C; 136.4 �F ), thermic coefficient of expansion of 12, 8 10 " 6 / K . It is used to parts where precision is necessary, as in inspections, and fusible cores to wax patterns compounds.
