The accumulated spark energy can be increased by adding a pair of Leyden jars, an early type of capacitor suitable for high voltages, with the jars inner plates independently connected to each of the output terminals and the jars outer plates interconnected.
32.
By connecting the inverter output terminals in sequence between the positive rail and ground, the positive rail and the negative rail, the ground rail and the negative rail, then both to the ground rail, a stepped waveform is generated at the inverter output.
33.
:: 45 % efficiency for a diesel generator sounds high, but are you only looking as far as the output terminals of the generator, and neglecting losses in transformers and transmission and distribution ? talk ) 02 : 16, 3 September 2013 ( UTC)
34.
There are " i " input calls entering via the same ingress switch as the free input terminal to be connected, and there are " j " calls leaving the Clos network ( output calls ) via the same egress switch as the free output terminal to be connected.
35.
However, the results do depend upon the main amplifier having a representation as a two-port that is, the results depend on the " same " current entering and leaving the input terminals, and likewise, the same current that leaves one output terminal must enter the other output terminal.
36.
However, the results do depend upon the main amplifier having a representation as a two-port that is, the results depend on the " same " current entering and leaving the input terminals, and likewise, the same current that leaves one output terminal must enter the other output terminal.
37.
If the resistor between the single output node and the inverting input node is R _ 2 and the resistor between a source voltage and the inverting input node is R _ 1, then the ideal gain for such a circuit at the output terminal is defined, ideally, to be:
38.
In the event that the RACE is to be used as a sampler ( and not a pulser ) the output value is desired to be held even after the sampling aperture is closed, and an optional capacitor CHOLD is connected between the two output terminals, as shown in FIG . 1.
39.
Opto-isolators using field-effect transistors ( FETs ) as sensors are rare and, like vactrols, can be used as remote-controlled analog potentiometers provided that the voltage across the FET's output terminal does not exceed a few hundred mV . Opto-FETs turn on without injecting switching charge in the output circuit, which is particularly useful in sample and hold circuits.
40.
Th is the voltage at the output terminals of the original circuit . It is the open circuited voltage at the output terminals of the original circuit . When calculating a Th�venin-equivalent voltage, the voltage divider principle is often useful, by declaring one terminal to be " V " out and the other terminal to be at the ground point.
