The Caprotti valve gear was driven by a single shaft, located between the frames, and driven from the leading coupled axle by a bevel gear.
42.
After engineers at Packard developed spiral bevel gears, Gleason pioneered the machine tools to mass-produce them ( with automotive differentials being the primary market ).
43.
The LG6 chassis is based on the one used on the torsion bar front suspension and live rear axle with Spiral bevel gear final drive.
44.
The winch is powered by bevel gears on a shaft driven directly from the engine, with some form of clutch providing raise / lower control.
45.
Bevel gears that have pitch angles of exactly 90 degrees have teeth that point outward parallel with the axis and resemble the points on a crown.
46.
Also note that the designations right hand and left hand are applied similarly to other types of bevel gear, hypoid gears, and oblique tooth face gears.
47.
It was a small, lightweight engine with single overhead camshaft driven by two sets of bevel gears and a vertical shaft at the front of the block.
48.
An alternative used in the early days of OHC engines was to drive the camshaft ( s ) via a vertical shaft with bevel gears at each end.
49.
A fundamental issue with bicycle shaft-drive systems is the requirement to transmit the torque of the rider through bevel gears with much smaller radii than typical bicycle sprockets.
50.
The joint works in a similar manner to a bevel gear with the balls bisecting the joint angle and functioning as the " teeth " to transmit torque.
