bus bar वाक्य
उदाहरण वाक्य
मोबाइल
- The sleigh-themed vehicles were powered by an electrical bus bar where portions of the track ascended, and they were gravity powered during the descents which featured several surprise dips.
- The output signal has only a magnetic connection with the bus bar so the bus may be, quite safely, at any ( EHT ) voltage with respect to the instrumentation.
- Zinsco electrical equipment is considered obsolete, due to a design flaw in which the circuit breaker's connection to the bus bar becomes loose, causing arcing and subsequent overheating.
- Or just put them in a concrete room and establish an arc at 480 volts or higher between two bus bars . talk ) 01 : 34, 15 January 2012 ( UTC)
- Because these increase the amount of power that can be supplied, all of the branch circuits must have their bus bars and circuit breakers upgraded to handle the new higher fault current limit.
- In addition to the three bus bars for power, there are three additional bus bars, one for a " GO " signal, one for a " NOGO " signal, and one for ground.
- In addition to the three bus bars for power, there are three additional bus bars, one for a " GO " signal, one for a " NOGO " signal, and one for ground.
- The output signal, proportional to the ampere turns in the control current bus bar, is derived from the alternating excitation voltage of the magnetic amplifier, there is no voltage created or induced on the bus bar.
- The output signal, proportional to the ampere turns in the control current bus bar, is derived from the alternating excitation voltage of the magnetic amplifier, there is no voltage created or induced on the bus bar.
- For example, an arc of several hundred amperes on a circuit normally carrying a thousand amperes may not trip overcurrent circuit breakers but can do enormous damage to bus bars or cables before it becomes a complete short circuit.
- A full area metal contact is made on the back surface, and a grid-like metal contact made up of fine " fingers " and larger " bus bars " are screen-printed onto the front surface using a silver paste.
- Similarly, in two adjacent conductors carrying alternating currents flowing in opposite directions, such as are found in power cables and pairs of bus bars, the current in each conductor is concentrated into a strip on the side facing the other conductor.
- When a circuit must be protected from overvoltage and there are failure modes in the power supply that can produce such overvoltages, the circuit may be protected by a device commonly called a crowbar across a set of bus bars ( exposed electrical conductors ).
- In the real world, two voltage sources connected by wires or even large copper bus bars would have the resistance of the wire or bus bar between them, and if its fraction of an ohm were put into the circuit analysis . you could calculate the huge current that would flow until something blew.
- In the real world, two voltage sources connected by wires or even large copper bus bars would have the resistance of the wire or bus bar between them, and if its fraction of an ohm were put into the circuit analysis . you could calculate the huge current that would flow until something blew.
- In " Engineering Electromagnetics ", Hayt points out that in a power station a busbar for alternating current at 60 Hz with a radius larger than one-third of an inch ( 8 mm ) is a waste of copper, and in practice bus bars for heavy AC current are rarely more than half an inch ( 12 mm ) thick except for mechanical reasons.
- To minimise this problem, the current connections to the standard resistor ( " R " " x " ); the sub-standard resistor ( " R " " s " ) and the connection between them ( " R " par ) is designed to have as low a resistance as possible, and the connections both in the resistors and the bridge more resemble bus bars rather than wire.
- अधिक वाक्य: 1 2
bus bar sentences in Hindi. What are the example sentences for bus bar? bus bar English meaning, translation, pronunciation, synonyms and example sentences are provided by Hindlish.com.