collector current वाक्य
उदाहरण वाक्य
मोबाइल
- The point on the load line where it intersects the collector current axis is referred to as " saturation point ".
- In active mode, the ratio of the collector current to the base current is called the " DC current gain ".
- The Early effect ( base-width modulation ) in Q1 will force its collector current to be slightly higher than that of Q2.
- Transistor Q3 is represented by its low-frequency hybrid-pi model with a current controlled dependent current source for the collector current.
- The process of obtaining a certain DC collector current at a certain DC collector voltage by setting up the operating point is called biasing.
- A lower base-resistor voltage drop reduces the base current, which results in less collector current because I c = ? I B.
- The ratio of these currents varies depending on the type of transistor, and even for a particular type, varies depending on the collector current.
- In this region, I c = ?I b where Ic is collector current and Ib is base current, following linear relation y = mx.
- The biasing base currents needed to evoke the quiescent collector currents usually come from the ground, pass through the input sources and enter the bases.
- Some basic circuits can be designed by assuming that the emitter base voltage is approximately constant, and that collector current is beta times the base current.
- Q1's collector current will be essentially zero, so R2 will pull the output voltage Q high ( logic 1; near V + ).
- Except at low collector-emitter voltages, the secondary breakdown limit restricts the collector current more than the steady-state power dissipation of the device.
- A saturated transistor is turned on hard, which means it has a lot more base drive than it needs for the collector current it is drawing.
- For positive voltages, the collector current through resistor 32 is less than the emitter current, so the base current is high to make up the difference.
- At low supply voltages ( typically 0.75 V and below ) the transistor requires a larger base current to maintain saturation as the collector current increases.
- In what follows, the output variable is selected as the short-circuit current of the amplifier, that is, the collector current of the output transistor.
- In a grounded-emitter transistor circuit, such as the light-switch circuit shown, as the base voltage rises, the emitter and collector currents rise exponentially.
- The turned on transistor's collector current will then pull the output Q low ( logic 0; V CE ( sat ) usually less than 1 volt ).
- Because Q 1 and Q 2 are matched, their ? 0-values also agree, making the mirror output current the same as the collector current of Q 1.
- All increases in voltage and current stop when the sum of the collector current of Q1 and base current of Q3 exactly balance \ scriptstyle i _ \ text { in }.
collector current sentences in Hindi. What are the example sentences for collector current? collector current English meaning, translation, pronunciation, synonyms and example sentences are provided by Hindlish.com.