tape punch वाक्य
उदाहरण वाक्य
मोबाइल
- Optionally, the AN-1 " Universal Code Accessory " included the " 35-4 " Friden Flexowriter and HSR-8 paper tape reader and HSP-8 paper tape punch.
- While the manufacturer called the Model 33 teleprinter with a tape punch and tape reader a Model 33 ASR, many users, specifically computer users, called this equipment an ASR-33.
- The Model 28 Tape Punch Set uses a standard 115 VAC 60 Hz synchronous motor is 9.75 inches high, 15.5 inches wide and 10 inches deep and weighs 24 pounds.
- The Model 28 family of tape punches includes the non-typing perforator ( LPE ), typing perforator ( LTPE ), non-typing reperforator ( LRPE ) and typing reperforator ( LPR ).
- The BRPE tape punches operate at 110 characters per second, with two adjustable-level versions for reading either 5 or 8-level paper tape or 6, 7 or 8-level paper tape.
- The Model 28 Tape Punches, also known as a tape perforators, are receiving-only five-level devices that is actuated by incoming line signals and perforates standard 11 / 16 inch paper tape.
- The DRPE tape punches operate at any speed up to 240 characters per second with an adjustable-level version for reading 6, 7 or 8-level paper tape and a fixed-level 6-level version.
- While there was an optional high-speed paper tape punch ( the PTP-1 at 60 digits per second ) for output, the standard punch operated at 17 hex characters per second ( 510 bytes per minute ).
- This time, it would be read in, haltingly, whilst the paper tape punch worked flat-out to produce the corresponding object tape ( usually two or three times longer in length than the Fortran source tape ).
- The first pass of the source tape through the tape reader was generally used just for checking for syntax errors in the program, so the generation of the object tape from the tape punch would be " suppressed ".
- The basic Model 35 was mounted in a light gray console that matched the width of the Model 33, while the Model 35 ASR with eight-level mechanical tape punch and reader was installed in a console about twice as wide.
- Four different tape punch units are available for use with the Model 28 ASR . These are the non-typing perforator ( LPE ), typing perforator ( LTPE ), non-typing reperforator ( LRPE ) and typing reperforator ( LPR ).
- The Model 28 Tape Punch Set is a multi-magnet reperforator, also known as the LARP, and capable of producing 5, 6, 7 or 8 level paper tape at speeds up to 20 characters per minute from a parallel wire input.
- Card and paper-tape punches each had a receptacle for the'chips'punched from the cards or tape to create the holes ( rectangular in a card, round in a paper tape ), which often looked like a bucket and was known by this name.
- All DRPE version paper tape punches were packaged in table-top and rack-mount models, with an optional verifier logic which read each character immediately after it was punched, compared it to the character received and provided an error output pulse if they did not agree.
- The 33 ASR also could be configured to employ Control-R ( DC2 ) and Control-T ( DC4 ) to start and stop the tape punch; on some units equipped with this function, the corresponding control character lettering on the keycap above the letter was TAPE and TAPE respectively.
- The architecture has a simple programmed I / O bus, plus a teletypes, paper tape punches and readers, while DMA is used for cathode ray tube screens with a light pen, analog-to-digital converters, digital-to-analog converters, tape drives, disk drives.
- Whilst the paper-tape punch was doing this, again spilling out its product ( albeit not so fast as the reader, and off to the left of the machine ) from its front panel mounting, the programmer could be winding up the old version of the source tape, for it to be kept as a backup version.
- The last TT-47 / UG was the TT-47L / UG . The U . S . Navy also assigned some " set " designations using the standard Army / Navy system, such as the AN / UGC-5, a Teletype Model 28 ASR which has a keyboard, printer, tape punch and reader facilities all in one cabinet.
- The Model 28 ASR keyboard base ( LAK ) supports the tape punch in addition to motor unit ( LMU ), typing unit ( LP ) and the code selecting and signal generator mechanisms of the Model 28 KSR . The Model 28 ASR tape reader, also known as the transmitter-distributor is mounted separately but powered by the same motor unit that powers the keyboard and typing unit.
tape punch sentences in Hindi. What are the example sentences for tape punch? tape punch English meaning, translation, pronunciation, synonyms and example sentences are provided by Hindlish.com.