On higher voltage systems ( on the order of kilovolts ) where a single phase transformer is in use to supply a low voltage system, the method of splitting varies.
2.
The alternators produced 50 Hz 3 phase AC at 11 kV, which was stepped up to 33 kV by two sets of three single phase transformers rated at 25 MW per set.
3.
:All winding turns in a single phase transformer has ( almost ) the same magnetic flux ?, the induced voltage in each winding turn is proportional to the rate of change of the flux d? / dt.
4.
In the US, which uses mostly single phase transformers, three identical single phase transformers are often wired in a " transformer bank " in either a wye or delta connection, to create a three phase transformer.
5.
In the US, which uses mostly single phase transformers, three identical single phase transformers are often wired in a " transformer bank " in either a wye or delta connection, to create a three phase transformer.
6.
My actual statement was : " The problem here is the mistaken belief in the North American convention that the two lines which result from centre tapping a single phase transformer secondary ( with the centre tap connected to ground ) can still be regarded as a single phase!
7.
I have tried a lot but dint got a satisfiable answer, so plz tell me wat exactly happens when we apply a heavy ac signal on primary of a single phase transformer, but keep secondary open . although power at primary is same as in normal cases because input voltage and current will be same . then where does this huge power goes . talk ) 16 : 43, 26 October 2008 ( UTC)
मोबाइल